Table of Contents
Advertisement
System Startup
Installation Steps
13. Turn on the printer or computer.
14. Turn on the AC power to each control module. All the keypads should briefly
display a revision screen and then the HOME screen. The printer should print
"WELCOME TO HORIZON..." If the HOME screen is not displayed and/or
there is no print-out, see Troubleshooting, page 38.
15. Using the Administrative Keypad, which is connected to the Master Control
Module, access the Setup screens. The Password is 1111 for a new system
installation.
16. If your system has one control module only , disable the CAN network.
17. Select CLEAR SETUP to intialize the system. Be sure to enter a new pass-
word for setup access before exiting Setup.
18. Using the administrative keypad, connected to the Master Control Module,
complete the System Setup. Use the six forms that were filled out in the
Pre-installation Procedure (refer to step 8, page 5) to enter the System
Map information into the Setup screens.
Test the System
Installation Steps
19. Request a dispense job for each fluid to each location. If any problems occur,
see Diagnostics, page 21, and Troubleshooting, page 38.
20. Select SETUP PRINT SETUP ALL MEMORY to print a record of all the
data entered during Setup. Send a copy of this record and all other required
documents as instructed in Pre-installation Form 6, W arranty Registration &
Checkout Form .
System Installation Complete
Installation Checklist
Reference
Page 15
Page 15
Page 16
Page 18
Pre-installation Forms
and Appendix, pages
56–65, or page 17,
Step 6
Reference
Pages 32 – 35
Pages 19 and 66
308–607
7
Advertisement
Table of Contents
