Table of Contents
Advertisement
System Setup – Time and Date
Instructions
Set Time and Date
NOTE: Only the Master Control Module can access the
TIME AND DATE screen.
1. With the cursor in the TIME field, type in the time.
Notice that the Horizon has a 24 hour clock.
2. Press ENTER on the keypad.
3. With the cursor in the DATE field, type in the date.
4. Press ENTER on the keypad.
System Setup – Operator Access
Instructions
Set Operator Access Information
1. With the cursor in the NAME field, type in the oper-
ators identification (maximum of 4 characters).
2. Press ENTER on the keypad.
3. With the cursor in the PASSWORD field, type in
four letters and/or numbers for the operator's pass-
word.
4. Press ENTER on the keypad.
5. With the cursor in the ACCESS field, scroll to the
correct access level using the
SETUP, or INVNT (inventory) can be entered.
Selecting RUN will allow the operator to use
the Run Menus only.
Selecting INVNT will allow the operator to use
the Run and Inventory Menus.
Selecting SETUP will allow the operator to use
all of the system menus.
6. Press ENTER on the keypad.
7. With the cursor at ADD, press ENTER to add
another operator. Or use the
DELETE and press ENTER to remove the entire
record.
This sequence will repeat until EXIT is selected,
then the SAVE SETUP screen will appear. See
page 25.
Saving the Setup
Follow the Save Setup procedure on page 25.
24
308–607
or
key. RUN,
or
key to scroll to
Screens
TIME
(HH:MM)
15:50
DATE (MMDDYY)
050296
15:50:08
TIME
(HH:MM)
15:50
DATE (MMDDYY)
050296
15:50:08
Screens
NAME:
PASSWORD:
ACCESS:
RUN
ADD
EXIT
NAME:
JOE
PASSWORD:
ACCESS:
RUN
ADD
EXIT
NAME:
JOE
PASSWORD:
1234
ACCESS:
RUN
ADD
EXIT
NAME:
JOE
PASSWORD:
1234
ACCESS:
RUN
ADD
EXIT
or
DELETE
or
DELETE
or
DELETE
or
DELETE
Advertisement
Table of Contents
