Table of Contents
Advertisement
Horizon System Components
1
Control Module
Control Module Component Identification
NOTE: See page 48 for more information about sys-
tem cables.
1. Cable Port Holes
a. Solenoid Cable Port Hole
b. AC Power Port Strain Relief
c. Pulse Meter Cable Port Hole
d. CAN Cable Port Hole
2. Keypad Cable Connector
Use to connect a keypad cable
3. Printer/Computer Connector
Used only on the Master Control Module to connect a
serial cable from a printer or computer
4. Solenoid Diagnostic LEDs
Indicate whether solenoid drivers are turned on
5. Solenoid Cable Connectors
Use to connect solenoid cable wires to the control
module
6
1a
3
2
4
13
6. Power Supply
Converts AC input power for use by control module
7. Power Supply Connector
Connects internal power supply to the electrical power
source
8. Electrical Power Cable Connector
Use to connect AC input electrical power cable wires to
the control module
9. Meter Cable Connectors
Use to connect pulse meter cable wires to the control
module
10. Pulse Meter Diagnostic LEDs
Indicate whether pulse meters are operating properly
11. Network Cable Connector
Use to connect network cable wires from other control
modules
12. DIP Switches
Use to set the control module address
13. Network Diagnostic LEDs
Indicates whether the control module network is
operating properly
7
8
10
5
2
12
1d
11
3
308–607
1b
9
1c
06799
43
Advertisement
Table of Contents
