Table of Contents
Advertisement
Instructions
6. Preset Dispense
NOTE: The unit of measurement (in this example, QT
or quart) is entered during the System Setup. There
are four units of measurement available: quarts, liters,
gallons, and pints.
a. The PRESET AMOUNT field appears with the
cursor on YES.
b. Press ENTER on the keypad while the YES is
displayed.
c. The ENTER AMT field appears on the fourth
line.
d. Type in the amount you want to dispense
(maximum of 999.9).
e. Press ENTER on the keypad.
f.
Continue with step 8.
7. Free Flow Dispense
a. The PRESET AMOUNT field appears with the
cursor on YES.
b. Press the
or
key to scroll to NO. Press
ENTER on the keypad while the NO is dis-
played.
8. Dispense Confirmation
a. Dispense amount, fluid name, dispense area
number and name are displayed on lines two
and three, under READY TO DISPENSE.
If operating with free flow dispense, the system
will display XXX.X in the dispense amount
field.
b. Cursor moves to the YES in the CORRECT?
field.
c. If the information is correct, press ENTER on
the keypad while the YES is displayed.
If the information is not correct, press the
key to scroll to NO. Press ENTER on the
keypad while the NO is displayed and re-enter
the data.
34
308–607
Run Mode – Dispensing
or
Screens
PRESET DISPENSE Screen
SEL FL:02 PENNZ5W20
SEL DA:03 BAY3
PRESET AMOUNT?: YES
SEL FL:02 PENNZ5W20
SEL DA:03 BAY3
PRESET AMOUNT?: YES
ENTER AMT: 000.0 QT
FREE FLOW DISPENSE Screen
SEL FL:02 PENNZ5W20
SEL DA:03 BAY3
PRESET AMOUNT?: NO
CONFIRMATION Screens
Preset Dispense
READY TO DISPENSE:
004.0 QT PENNZ5W20
TO DA 03 BAY3
CORRECT? YES
Free Flow Dispense
READY TO DISPENSE:
XXX.X QT PENNZ5W20
TO DA 03 BAY3
CORRECT? YES
Advertisement
Table of Contents
