Figure 27: Marking The Mounting Base Holes On The Wall - Allied Telesis TQ6702e GEN2 Installation Manual

c
Figure 27. Marking the Mounting Base Holes on the Wall
3. Pre-drill the marked locations on the wall.
4. Install the provided wall anchors in the holes.
5. Place the access point upside-down on a table or desk.
6. Attach the mounting base to the bottom of the access point with the
provided screws, spring washers, and washers, using a Phillips-head
screwdriver. See Figure 28 on page 54.
Note
Attach the ground cable to the access point before attaching the
mounting base. See "Attaching the Ground Cable to the Access
Point" on page 39.
Chapter 2: Installing the Access Point
53