Table of Contents
Advertisement
TQ6702e GEN2 Outdoor Access Point Installation Guide
Power over
Ethernet (PoE++)
Connector Type
Speed
Duplex Mode
26
The TQ6702e GEN2 access point supports Power over Ethernet Plus
(PoE++) on the LAN port. As such, the access point receives its power
from a PoE++ source device over the network cable that also carries the
network traffic. The product is a PoE++ class 5 powered device with a
maximum power consumption of 29.2 watts. The device does not have an
internal power supply and it does not support an external AC/DC power
adapter. It has to be powered by a PoE++ source device on its LAN port.
Note
The PoE++ source device that supplies power to this device, such
as a switch, must be a UL listed Information Technology Equipment
(ITE).
The LAN port has an eight-pin RJ45 connector. The port uses four pins at
100 Mbps and all eight pins at 1000 Mbps and higher speeds. The pin
assignments are listed in "LAN Port" on page 87.
The LAN port can operate at 100M/1000M/2.5G/5Gbps. The speed is set
automatically with Auto-Negotiation. You cannot disable Auto-Negotiation
on the port.
Note
The LAN port should be connected to a network device that also
adjusts its speed with Auto-Negotiation.
The LAN port can operate in either half- or full-duplex mode at 100 Mbps,
and full-duplex mode at 1000M/2.5G/5Gbps. The port is IEEE802.3u-
compliant and uses Auto-Negotiation to set the duplex mode. You cannot
disable Auto-Negotiation on the port.
Ethernet LAN Port
Figure 3. Ethernet LAN Port
Advertisement
Table of Contents
