Table of Contents
Advertisement
TQ6702e GEN2 Outdoor Access Point Installation Guide
Reset Button
28
The LEDs are described in Table 3.
LED
State
LAN
Solid Green The LAN port is receiving power from a PoE++
Blinking
Green
Off
WLAN
Solid Green One or both radios (i.e., Radio1, Radio2, or
Off
Power
Solid Green The power from the PoE++ source device is
Blinking
Green
Off
The access point has a reset button under the transparent cap on the front
panel. Refer to Figure 5.
Table 3. LEDs
Description
source device and is operating normally.
The LAN port is receiving power from a PoE++
source device and is transmitting/receiving
network traffic.
The access point is powered off because the
LAN port is not receiving power from a PoE++
source device.
both) are enabled.
All radios are disabled or the access point is
powered off.
within the normal operating range.
The access point is booting up or upgrading its
firmware.
The access point is not receiving power from a
PoE++ source device on the Ethernet LAN port,
Figure 5. Reset Button
Advertisement
Table of Contents
