Attaching The Antennas To The Access Point; Figure 18: Attaching A Surge Protector To An Antenna Connector; Figure 19: Screwing The Nut Onto The Surge Protector - Allied Telesis TQ6702e GEN2 Installation Manual

TQ6702e GEN2 Outdoor Access Point Installation Guide

Attaching the Antennas to the Access Point

46
To install the antennas, perform the following procedure:
Note
You must install 5GHz antennas to 5GHz antenna connectors and
2.4GHz antennas to 2.4GHz antenna connectors.
1. Remove the blind caps covering the antenna connectors.
2. Screw a surge protector to an antenna connector. See Figure 18.
Figure 18. Attaching a Surge Protector to an Antenna Connector
3. Screw the nut onto the surge protector. Refer to Figure 19.
Figure 19. Screwing the Nut onto the Surge Protector