Mounting The Base Plate To The Wall Or Ceiling; Figure 4: Base Plate Hole Dimensions; Figure 5: Mounting Base Plate - Allied Telesis AT-AP500 Installation Manual

Chapter 2: Installing the Access Point
Mounting the
Base Plate to the
Wall or Ceiling
24
Draft 11-11-2016
To mount the base plate to the wall or ceiling, perform the following:
1. Using the base plate as a template, mark the four holes for mounting
the base plate to the wall or ceiling. See Figure 4 for hole dimensions.
Figure 4. Base Plate Hole Dimensions
2. Drill the holes for the four self-tapping screws, and if applicable, two
wall anchors.
3. If you are not installing wall anchors, skip to Step 4. If so, install the
wall anchors.
4. Mount the base plate to the wall or ceiling using the self-tapping
screws, as shown in Figure 5.
Figure 5. Mounting Base Plate