Chapter 2: Installing The Access Point - Allied Telesis TQ6702e GEN2 Installation Manual

Chapter 2
Installing the Access Point
This chapter contains the following installation procedures for the
TQ6702e GEN2 access point:
"Reviewing Safety Precautions" on page 34

"Unpacking the Access Point" on page 36

"Attaching the Ground Cable to the Access Point" on page 39

"Connecting an Ethernet Cable to the Access Point" on page 42

"Attaching the Antennas to the Access Point" on page 46

"Installing the Access Point" on page 49

"Installing the Access Point on a Wall" on page 52

"Installing the Access Point on a Pole" on page 56

"Installing on a Pole Using the U-Bolts and Pole-Mount Bracket" on

page 59
"Installing on a Pole Using the Pole Straps and Mounting Base" on

page 62
"Starting the First Management Session on the Access Point" on

page 67
"Setting the Country and Location" on page 69

Note
The non-US model of this product has a country code setting that
must be set during the initial management session of the unit. The
setting ensures that the unit operates in compliance with the laws
and regulations of your country or region.
For the US model, the country code is preset and cannot be
changed. Per FCC regulations, the country code setting for all WiFi
products marketed in the US must be fixed to US operational
channels only.
33