Attaching The Cable To The Tq6702E Gen2 Access Point; Figure 44: Cables And Antenna Connectors On The Tq6702E Gen2 Access Point - Allied Telesis TQ6702e GEN2 Installation Manual

TQ6702e GEN2 Outdoor Access Point Installation Guide
Attaching the
Cable to the
TQ6702e GEN2
Access Point
80
5, 6, 7, and 8
Figure 44. Cables and Antenna Connectors on the TQ6702e GEN2
To attach the cables to the TQ6702e GEN2 access point, perform the
following procedure:
Note
You must install 5GHz antennas to 5GHz antenna connectors and
2.4GHz antennas to 2.4GHz antenna connectors.
1. Remove the connector blind caps covering the antenna connectors.
2. Screw the cable to an antenna connector. See Figure 45 on page 81.
Access Point
1, 2, 3, and 4