Table of Contents
Advertisement
Chapter 2: Installing the Wireless Access Point
Installing the Mounting Bracket on a Wall or Ceiling
46
To install the mounting bracket on a wall of ceiling, perform the following
procedure:
1. Choose the location and orientation for the access point on the wall or
ceiling. Refer to Figure 12 on page 41.
2. Position the mounting bracket at the selected location and orientation
for the access point. Consider the following guidelines.
The thumbscrew on the mounting bracket is where the front panel
of the access point will be.
The ports and connectors are on the back panel, away from the
thumbscrew.
3. With a pencil, mark the wall or ceiling with the two key-hole slots of the
bracket. Refer to Figure 17.
Figure 17. Marking the Holes for the Key-Hole Slots
4. Pre-drill the two marked locations for the keyhole slots on the
hard-surface ceiling or wall.
Advertisement
Table of Contents
