Table of Contents
Advertisement
TQ6702e GEN2 Outdoor Access Point Installation Guide
Installing the Access Point on a Wall
What to Prepare
for Wall
Installation
Installing the
Access Point on a
Wall
52
This section contains the procedures for installing the TQ6702e GEN2
access point on a wall.
You need the following items to install the access point on a wall:
TQ6702e GEN2 Access Point
Mounting base
Four screws for the mounting base
Screws for the wall, one of the following:
–
Four sets of the bolt, nut, washer, and wall anchor
for a concrete wall
–
Four tapping screws for a regular wall
Drill
Phillips-head screwdriver
Pencil
Note
Screws for the wall, drill, Phillip-head screwdriver, and pencil are not
included with the product.
To install the access point on the wall, perform the following procedure:
1. Review "Guidelines to Installing the Access Point on a Fixture" on
page 49.
2. Hold the mounting base on the wall at the desired location for the
access point and mark the four mounting base holes with a pencil. See
Figure 27.
Note
The mounting base can be in a vertical or horizontal position. see
Figure 24 on page 49.
Advertisement
Table of Contents
