Table of Contents
Advertisement
Figure 16. Connecting the LAN Cable to the Ethernet LAN Port
8. Tighten the sealing nut on the access point. Refer to Figure 17.
Figure 17. Tightening the Sealing Nut
Note
The next step powers on the access point by attaching the Ethernet
cable to a port on a PoE++ source device. Allied Telesis
recommends not performing the step until you have completed all of
the installation procedures.
9. Connect the other end of the Ethernet cable to a port on a PoE++
source device, such as a PoE++ switch.
Chapter 2: Installing the Access Point
45
Advertisement
Table of Contents
