Overview To Installing The Access Point On A Wall Or Ceiling - Allied Telesis AT-TQ6602 GEN2 Installation Manual

Overview to Installing the Access Point on a Wall or Ceiling

Here are the procedures for installing the wireless access point on a wall
or ceiling:
"Pre-fitting the Mounting Bracket on the Access Point" on page 40

"Installing the Mounting Bracket on a Wall or Ceiling" on page 42

"Connecting Ethernet Cables to LAN1 and LAN2 Ports" on page 46

"Connecting the AC Power Adapter" on page 48

"Attaching the Access Point to the Mounting Bracket" on page 49

"Installing an Anti-theft Device" on page 52

Note
Please see "Reviewing Safety Precautions" on page 32 and
"Reviewing Installation Guidelines" on page 36 before installing the
product.
Note
Depending on the installation location, it may be easier to connect
the network cables and optional power adapter to the wireless
access point before installing it on the wall or ceiling.
You need the following items to install the wireless access point on a
ceiling or wall:
TQ6602 GEN2 or TQm6602 GEN2 Access Point

Two screws to attach the access point to the mounting bracket

Mounting bracket

Four (4) M4, 25.0 mm flat-head wood screws and anchors (not

provided) for fastening the mounting bracket
Phillips head screwdriver (not provided)

Pencil (not provided)

External AC power adapter (Optional if using PoE+. Required if not

using PoE+ or for redundant power.)
Kensington lock (optional and not provided)

Note
The four Phillips head M4 screws/anchors, the Phillips head
screwdriver, pencil, external AC power adapter and Kensington lock
are not included with the product.
TQ6602 GEN2 Access Points Installation Guide
39