Installing The Access Point On A Celling Or Wall; Guidelines For Installing The Device On A Celling Or Wall - Allied Telesis AT-MWS600AP Installation Manual

Chapter 2: Installing the AT-MWS2533AP Access Point

Installing the Access Point on a Celling or Wall

Guidelines for
Installing the
Device on a
Celling or Wall
Correct
34
The AT-MWS2533AP access point can be mounted on a celling or wall.
Review the following guidelines before installing the access point on a
ceiling or wall:
You must provide the four self-tapping screws that secure the

mounting base plate to the ceiling or wall.
The ceiling or wall mounting surface must be of proper material to

accommodate the self-tapping screws, strong enough to support
the weight of the equipment and cables.
Connect the Ethernet cable to the access point before installing the

access point on the ceiling or wall if connecting the Ethernet cable
will be difficult after the access point is installed.
The AT-MWS2533AP access point can be installed on a ceiling or

tabletop. See Figure 7.
Correct Tabletop Installation
Figure 7. Correct Ceiling or Tabletop Installation
The AT-MWS2533AP access point can be mounted on the wall;

however, installing the access point with the LAN ports facing up is
not allowed. See Figure 8 for correct and incorrect wall installation
orientations.
Correct
Figure 8. Correct and Incorrect Wall Installation
Correct Ceiling Installation
Correct Incorrect