Removing The Boss-N1 Module - Dell PowerEdge R960 Installation And Service Manual

Steps
Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
Figure 145. Installing the BOSS-N1 card carrier blank

Removing the BOSS-N1 module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If required, Remove the support
4. If required, Remove the air shroud top
5. If required,Remove the cooling fan cage
6. If required, Remove the air
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
Figure 146. Removing the BOSS-N1 card carrier
3. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1
card carrier.
4. Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
Safety instructions.
Before working inside your
bar.
cover.
assembly.
shroud.
system.
Installing and removing system components 171