Dell PowerEdge R960 Installation And Service Manual page 179

9. If required, remove the
Steps
1. Connect the USB key to the internal USB card.
NOTE: For information about the exact location of USB on system board, see
section.
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 157. Installing the internal USB card
Next steps
1. If removed, install the
2. Install the riser air shroud.
3. Install the expansion card risers
4. Install the air shroud
5. Install the cooling fan cage
6. Install the air shroud top
7. Install the support bar.
8. Follow the procedure listed in
9. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
PEM.
PEM.
or Install the full length expansion card
assembly.
cover.
After working inside your
riser.
system.
Installing and removing system components
System board jumpers and connectors
179