Pem Power Board; Removing The Pem Power Board - Dell PowerEdge R960 Installation And Service Manual

Figure 135. Installing the PEM
Next steps
1. If removed, install processor and heat sink module
NOTE: Rotate the PEM module handle to the mid position to install the cables/connectors and the heat sink modules to
the PEM board.
2. Connect all the UPI and riser cables to the PEM, observe the cable routing.
3. If removed, Install the full length expansion
NOTE: Before installing the full length expansion card risers, install the GPU air shroud.
4. Install the air shroud or
5. Install the cooling fan cage
6. Install the air shroud top
7. Install the support bar.
8. Follow the procedure listed in

PEM power board

This is a service technician replaceable part only.

Removing the PEM power board

There are three PEM power boards on the system board. The procedure to remove is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the support bar.
4. Remove the air shroud top
5. Remove the cooling fan cage
164 Installing and removing system components
risers.
install the GPU air shroud.
assembly.
cover.
After working inside your
Safety instructions.
Before working inside your
cover.
assembly.
on the PEM.
system.
system.