Next steps
1.
Replace the power distribution
Installing the power distribution board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the support
bar.
4.
Remove the air shroud top
5.
Remove the cooling fan cage
6. If required,
Remove the air
7.
Remove the expansion card risers
NOTE:
See
cable routing
8.
Remove the riser air
shroud.
9.
Remove the
PSU.
Steps
1. Align and lower the power distribution board (PDB) into the system board slot.
2. Press the blue touch point on the PDB until seated firmly.
3. Tighten the captive screw.
Figure 122. Installing the PDB
Next steps
1.
Install the
PSU.
2.
Install the riser air
shroud.
3.
Install the expansion card risers
4. If removed,
Install the air shroud
5.
Install the cooling fan cage
6.
Install the air shroud top
7.
Install the support
bar.
8. Follow the procedure listed in
152
Installing and removing system components
board.
Safety
instructions.
Before working inside your
cover.
assembly.
shroud.
or
remove the full length expansion card
section for more information.
or
Install the full length expansion card
assembly.
cover.
After working inside your
system.
riser.
riser.
system.