Dell PowerEdge R960 Installation And Service Manual page 162

4. Remove the air shroud top
5. Remove the cooling fan cage
6. Remove the air shroud
NOTE: The GPU air shroud can be removed only after the full length expansion card risers have been removed.
7. Disconnect all the UPI and riser cables from the PEM, observe the cable routing.
NOTE: See cable routing
8. If installed, remove the full length expansion card
9. If required, remove the processor and heat sink module
NOTE: Rotate the PEM handle to the mid position to remove the cables/connectors and the heat sink modules that are
installed on the PEM board.
Steps
1. Rotate the PEM handle to unlock the PEM from the system.
2. Hold the handle, and lift the PEM away from the system.
CAUTION: Handle with care because the PEM is heavy, and lay it down on a flat surface.
Figure 134. Removing the PEM
Next steps
1. Before replacing the processor expansion module (PEM):
a. Remove Memory modules
b. Remove Processor and heat sink module
NOTE: Rotate the PEM handle to the mid position to remove the heat sink modules installed on the faulty PEM.
c. Install Processor and heat sink module
NOTE: Rotate the PEM handle to the mid position to install the heat sink modules to the replacement PEM.
d. Install Memory modules
2. Replace the processor expansion
162 Installing and removing system components
cover.
assembly.
or remove the GPU air shroud.
section for more information.
from the faulty PEM
from the faulty PEM
into the replacement PEM
into the replacement PEM
module.
risers.
on the PEM