Dell PowerEdge R960 Installation And Service Manual page 168

5. Remove the cooling fan cage
6. Remove the air shroud
NOTE: The GPU air shroud can be removed only after the full length expansion card risers have been removed.
7. Remove the expansion card risers
NOTE: See cable routing
8. Remove the riser air shroud.
Steps
1. If available, open the latch and remove the filler bracket from the VGA bracket .
2. Slide the VGA and Serial COM port into the VGA bracket and close the latch.
Figure 140. Installing the VGA and Serial COM port
3. Connect the VGA and Serial COM port cable to the liquid cooling rear I/O board.
4. Align the guide pin on the VGA bracket with the slot on the system.
5. Lower the VGA bracket and tighten the captive screws.
Figure 141. Installing the VGA bracket
Next steps
1. Install the riser air shroud.
2. Install the expansion card risers
NOTE: Before installing the full length expansion card risers, install the GPU air shroud.
168 Installing and removing system components
assembly.
or remove the GPU air shroud.
or remove the full length expansion card
section for more information.
or Install the full length expansion card
riser.
riser.