Table of Contents
Advertisement
Figure 155. Installing the system battery
Next steps
1.
Install the cooling fan cage
2. Follow the procedure listed in
3. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, check the time and date at least an hour after installing the battery.
e. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB card
NOTE:
To locate the internal USB port on the system board, see the
Removing the internal USB card
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the support
bar.
4.
Remove the air shroud top
5.
Remove the cooling fan cage
assembly.
After working inside your
Safety
instructions.
Before working inside your
cover.
assembly.
system.
Getting help
System board jumpers and connectors
system.
Installing and removing system components
section.
section.
177
Advertisement
Table of Contents
