Table of Contents
Advertisement
Figure 126. Removing the retaining clip
Next steps
Replace the
processor.
Installing the processor
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the support
bar.
4.
Remove the air shroud top
5.
Remove the cooling fan cage
6.
Remove the air shroud
NOTE:
The GPU air shroud can be removed only after the full length expansion card risers have been removed.
7.
Remove the
PEM, if the system board processor and heat sink module (PHM) must be accessed.
8. If required,
Remove the full length expansion card
9.
Remove the processor heat sink
Steps
1. Place the processor in the processor tray.
NOTE:
Ensure the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Place the retaining clip on top of the processor in the processor tray aligning pin 1 indicator on the processor.
NOTE:
Ensure the pin 1 indicator on the retaining clip is aligned with the pin 1 indicator on the processor before placing
the retaining clip on the processor.
NOTE:
Before you install the heat sink, ensure to place the processor and retaining clip in the tray.
156
Installing and removing system components
Safety
instructions.
Before working inside your
cover.
assembly.
or
remove the GPU air
shroud.
module.
system.
risers.
Advertisement
Table of Contents
