Dell PowerEdge R960 Installation And Service Manual page 200

4. Remove the air shroud top
5. Remove the cooling fan cage
6. If installed, Remove the air shroud
NOTE: The GPU air shroud can be removed only after the full length expansion card risers have been removed.
7. If required, Remove the expansion card risers
NOTE: See cable routing
8. Disconnect the UPI and riser cables from the PEM.
9. Remove the PEM.
10. Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel and cable cover to the system.
2. Remove the cable cover away from the system.
3. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
4. Holding the right control panel and VGA cable assembly, slide the right control panel out of the system.
NOTE: Observe the routing of the cable assembly as you remove the right control panel from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 181. Removing the right control panel
Next steps
1. Replace the right control
200 Installing and removing system components
cover.
assembly.
or remove the GPU air
or
section for more information.
bracket.
panel.
shroud.
remove the full length expansion card riser.