Processor Expansion Module; Removing The Processor Expansion Module (Pem) - Dell PowerEdge R960 Installation And Service Manual

Figure 133. Set the anti-tilt wires to the locked position and tightening the nuts
Next steps
1. If removed, install the
2. If removed, Install the full length expansion
NOTE: Before installing the full length expansion card risers, install the GPU air shroud.
3. Install the air shroud or
4. Install the cooling fan cage
5. Install the air shroud top
6. Install the support bar.
7. Follow the procedure listed in the

Processor expansion module

This is a service technician replaceable part only.

Removing the processor expansion module (PEM)

Prerequisites
NOTE: A PEM is required to install the third and the fourth processors. In order to replace the PEM board, the complete
PEM must be replaced.
NOTE: Remove the faulty PEM from the system and transfer the DIMMs and processor heat sink modules to the
replacement PEM before installing it in the system.
CAUTION: Do not lift the PEM board by holding the memory module, processor, or any other components. Use
the handle bar on the module to lift.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the support bar.
PEM.
risers.
install the GPU air shroud.
assembly.
cover.
After working inside your
Safety
Before working inside your
system.
instructions.
system.
Installing and removing system components 161