Table of Contents
Advertisement
Figure 167. Installing a power supply unit adapter
Next steps
1.
Install the expansion card risers
NOTE:
Before installing the full length expansion card risers, install the GPU air shroud.
2.
Install the air shroud
or
3.
Install the cooling fan cage
4.
Install the air shroud top
5.
Install the support
bar.
6.
Install the
PSU.
7. Follow the procedure listed in
Removing a power supply unit
Prerequisites
CAUTION:
The system requires one power supply unit (PSU) for normal operation. On power-redundant
systems, remove and replace only one PSU at a time in a system that is powered on.
1. Follow the safety guidelines listed in the
2. Disconnect the power cable from the power outlet and from the PSU that you intend to remove.
3. Remove the cable from the strap on the PSU handle.
4. Unlatch and lift or remove the optional cable management accessory if it interferes with the PSU removal.
NOTE:
For information about the cable management when the PSU is removed or installed while the system is in a rack,
see the system's cable management arm documentation at https://www.dell.com/poweredgemanuals.
Steps
Press the release latch and holding the PSU handle, slide the PSU out of the bay.
188
Installing and removing system components
or
Install the full length expansion card
install the GPU air shroud
assembly.
cover.
After working inside your
Safety
instructions.
riser.
system.
Advertisement
Table of Contents
