Removing A Gpu - Dell PowerEdge R960 Installation And Service Manual

Figure 114. Installing the expansion card riser 4
Next steps
1. Connect all the riser cables to the PEM connectors, observe the cable routing.
NOTE: See cable routing
2. If removed, connect the BOSS-N1 signal and power cable to the connectors on the BOSS module.
3. Install the cooling fan cage
4. Install the air shroud top
5. Install the support bar.
6. Follow the procedure listed in
7. Install any device drivers required for the card as described in the documentation for the card.

Removing a GPU

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the support bar.
4. Remove the air shroud top
5. Remove the cooling fan cage
6. Remove the full length expansion card
NOTE: See cable routing
Steps
1. To remove the GPU from Risers:
a. Slide the expansion card retention latch on the riser .
b. Before removing the card from the riser, pull and tilt the card holder by pressing the touch point on the card holder.
c. Press and tilt the expansion card holder latch on the riser.
d. Disconnect the GPU power cable from the GPU card.
e. Hold the GPU card by the edges and pull the card from the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
146 Installing and removing system components
section for more information.
assembly.
cover.
After working inside your
Safety instructions.
Before working inside your
cover.
assembly.
riser.
section for more information.
system.
system.