3.
Remove the support
bar.
4.
Remove the air shroud top
5.
Remove the cooling fan cage
6. If required,
remove the air shroud
7. Disconnect the cables, observe the cable routing.
NOTE:
See
cable routing
8. If required,
remove the
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Figure 74. Removing the rear mounting front PERC module
Next steps
1.
Replace the rear mounting front PERC
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the support
bar.
4.
Remove the air shroud top
5.
Remove the cooling fan cage
6. If required,
remove the air shroud
7. Disconnect the cables, observe the cable routing.
NOTE:
See
cable routing
8. If required,
remove the
Steps
1. Align the connectors and guide slots on the rear mounting front PERC module with the connectors and guide pins on the
drive backplane.
2. Slide the rear mounting front PERC module until the module is connected to the drive backplane.
cover.
assembly.
or
remove the GPU air
section for more information.
PEM.
module.
Safety
instructions.
Before working inside your
cover.
assembly.
or
remove the GPU air
section for more information.
PEM.
shroud.
system.
shroud.
Installing and removing system components
109