Installing The Side Wall Bracket - Dell PowerEdge R960 Installation And Service Manual

Steps
1. Press the tabs to release the side wall cable holder.
NOTE: Move the cables out of the side wall cable holder and observe the cable routing.
2. Press the center tab to release the bracket from the chassis, and lift it away from the system.
Figure 57. Removing the side wall bracket
Next steps
1. Replace the side wall

Installing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to install is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the support bar.
4. Remove the air shroud top
5. Remove the cooling fan cage
6. If required, remove the air shroud
Steps
1. Align the guide slots on the side wall bracket with the guides on the system and slide until the cover is seated firmly.
NOTE: Route the cables through the side wall cable holder properly to prevent the cables being pinched or crimped.
2. Close the side wall cable holder until the holder clicks into place.
bracket.
Safety
Before working inside your
cover.
assembly.
or remove the GPU air
instructions.
system.
shroud.
Installing and removing system components 95