Table of Contents
Advertisement
6. If installed,
remove the air shroud
NOTE:
The GPU air shroud can be removed only after the full length expansion card risers have been removed.
7. If installed,
Remove the full length expansion card
NOTE:
See
cable routing
8. Disconnect the UPI and riser cables from the PEM.
9.
Remove the
PEM.
Steps
1. Using a flat blade screwdriver remove the PEM power board cover.
2. Holding the PEM power board by its edges lift the power board from the connector on the system board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 136. Removing the PEM power board
Next steps
1.
Replace the power distribution
Installing the PEM power board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the support
bar.
4.
Remove the air shroud top
5.
Remove the cooling fan cage
6. If installed,
remove the air shroud
NOTE:
The GPU air shroud can be removed only after the full length expansion card risers have been removed.
7. If installed,
Remove the full length expansion card
NOTE:
See
cable routing
8. Disconnect the UPI and riser cables from the PEM.
9.
Remove the
PEM.
or
remove the GPU air
riser.
section for more information.
board.
Safety
instructions.
Before working inside your
cover.
assembly.
or
remove the GPU air
riser.
section for more information.
shroud.
system.
shroud.
Installing and removing system components
165
Advertisement
Table of Contents
