Table of Contents
Advertisement
Figure 147. Removing the M.2 NVMe SSD
5. Disconnect the BOSS-N1 power and signal cable from the system board.
6. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS-N1 module on Riser 1.
7. Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Figure 148. Removing the BOSS-N1 module
8. Pull the blue tag to remove the BOSS-N1 signal cable from the BOSS-N1 module.
9. Remove the BOSS-N1 power cable from the BOSS-N1 module.
172
Installing and removing system components
Advertisement
Table of Contents
