M.2 SSD module
Removing the BOSS-N1 controller card module for 6 x 2.5-inch
configuration
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
Figure 121. Removing the BOSS-N1 card carrier
3. Using the Phillips 1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card carrier.
4. Slide the M.2 SSD out and up from the BOSS-N1 card carrier.
Figure 122. Removing the M.2 SSD
5. Disconnect the BOSS-N1 power cable and signal cable from the system board.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
153