Aligning The Image With Lens Zoom And Focus; Running Auto Setup To Optimize Display Settings; Configuring Boxer 30 To Work With Christie Link - Christie Boxer 30 Installation And Setup Manual

5. When complete, push in all the convergence adjustment knobs to disengage the knobs.

Aligning the image with lens zoom and focus

Ensure the image reflected from the digital micromirror device (DMD) is parallel and centered with the
lens and screen.
1. Display an image or test pattern that can be used to analyze image focus and geometry.
2. Select ZOOM.
3. Use the up and down arrows to zoom in or out of the image.
4. To exit, select Back.
5. Select FOCUS.
6. Use the up and down arrows to adjust the focus of the image.
7. To exit, select Back.
8. To refine your adjusts, repeat steps 2 to 7.

Running Auto Setup to optimize display settings

Auto Setup initiates an automated process in which the projector optimizes video settings for the
active signal. Auto Setup helps to save time in perfecting a display and you can modify the
adjustments as required.
1. Make sure of the following before running Auto Setup:
• Test patterns are turned off (on page 32).
• The active signal is valid.
2. From the remote, select Auto Signal.
From the web UI, select Auto Setup.
3. Select Run Auto Setup.
The system optimizes the active signal and displays a progress message on screen.

Configuring Boxer 30 to work with Christie Link

Configure Boxer 30 to work with Christie Link, which provides a fully integrated fiber solution for long
range video transport.
1. Turn on Boxer 30.
2. From the side panel home page, verify the Boxer firmware is v1.3.0 or later.
3. Verify the HBMIC has been installed in slot 0.
4. To enable the Christie Link option, select MENU > Configuration > Input Settings >
Enable Christie Link (Slot 0).
This option is disabled if an HBMIC is not installed.
5. Select Enter.
6. Select the QSFP+ option as the input setting.
a) From the side panel home page, select Input.
Boxer 30 (Bb.2) Installation and Setup Guide
020-102017-08 Rev. 1 (02-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
31