Turning On The System - Christie Mirage SST User Manual

Hide thumbs Also See for Mirage SST:

Table of Contents

lasers approximately 10 to 15 minutes to warm up when turning on the first time from the off

position. This could be longer if the start-up temperatures are approaching minimum or

maximum temperatures for operation. The projector will operate with the shutter closed until

the lasers are warmed up.

Turning on the system

After the system has been initiated for the first time, not all steps need to be performed when

subsequently turning on the system.

Warning! If not avoided, the following could result in death or serious injury.

•

SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage

and current, as specified on the license label.

Never run the laser illumination source without the cooling system already running. The chiller must

be the first item turned on before power is applied to the laser rack and kept operating until after the

AC lockout/switch is rotated to the off position.

1. Turn on the chiller.

For more information on how to turn on the chiller, refer to the chiller's product

documentation.

2. Check the coolant level. If the coolant level is low, add coolant and check for leaks.

3. On the laser illumination source, rotate the main AC lockout/switch (A) to the on position and

rotate the Power key (B) clockwise to the on position.

The Interlock status indicator (C) on the laser illumination source turns yellow.

4. If the breaker is off, on the projector beside the AC inlet, move the AC breaker/switch to the

on position.

The projector boots into standby mode after approximately 30 seconds.

Mirage SST User Guide

020-102993-01 Rev. 1 (06-2019)

Operating the projector

Table of Contents