Figure 4-3: Handwheel Interconnection To Aux I/O Connector; Figure 4-4: Handwheel Interconnection To The Aux I/O Through A Bba32 Module - Aerotech Automation1 iXC4e Hardware Manual

iXC4e/XC4e
4.2. Handwheel Interface
A handwheel can be used to manually control axis position. The handwheel must provide 5V
differential quadrature signals to the drive.
IMPORTANT: You can find instructions on how to enable the handwheel in the online
Help
Connect a handwheel to the Aux I/O as shown in
Figure 4-3: Handwheel Interconnection to Aux I/O Connector
Figure 4-4: Handwheel Interconnection to the Aux I/O through a BBA32 Module
104
file.
Figure 4-3 or Figure 4-4.
Hardware Manual
www.aerotech.com