Motor Power Output Connector; Table 2-7: Motor Power Output Connector Pinout; Table 2-8: Motor Power Output Mating Connector Ratings - Aerotech Automation1 iXC4e Hardware Manual

Hardware Manual

2.2. Motor Power Output Connector

DANGER: Before you do maintenance to the equipment, disconnect the electrical
power. Wait at least ten (10) minutes after removing the power supply before doing
maintenance or an inspection. Otherwise, there is the danger of electric shock.
The drive can be used to drive the following motor types:
Brushless (refer to
l
DC Brush (refer to
l
Stepper (refer to
l
For a complete list of electrical specifications, refer to
DANGER: Shock and Fire Hazard
Electrical wiring must be designed and installed in accordance with local electrical
safety regulations to prevent the risk of fire and electrical shock.
Table 2-7: Motor Power Output Connector Pinout
Pin Description
A Motor Phase A Output
B Motor Phase B Output
C Motor Phase C Output
Motor Ground
Table 2-8: Motor Power Output Mating Connector Ratings
Specification
Type
Part Numbers
One conductor, stranded with ferrule
and plastic sleeve
Conductor
Cross Section
Two conductors (same cross-section),
stranded, twin ferrule with plastic sleeve
Tightening Torque
Conductor Insulation Strip Length
(1) Refer to the manufacturer website for additional information.
www.aerotech.com
Section 2.2.1.)
Section 2.2.2.)
Section 2.2.3.)
Section 1.1.
Description
7-Pin Terminal Block
Aerotech: ECK02387
Phoenix: 1756353
14...22 AWG (0.25...2.5 mm
16...20 AWG (0.5...1.5 mm
0.5...0.6 N·m
7 mm (0.25 in)
iXC4e/XC4e
Connector
2
)
2
)
37