Hardware Manual
3.3. Analog Outputs [-EB1]
The analog outputs can be set from within a program or they can be configured to echo the state of
select servo loop nodes.
The analog outputs are set to zero when you power on the system or reset the drive.
Table 3-9:
Analog Output Specifications [-EB1]
Specification
Output Voltage
Output Current
Resolution (bits)
Table 3-10:
Analog Output Connector Pinout [-EB1]
Pin # Description
1
Analog Output 1
2
Analog Output 2
3
Analog Output 3
4
Ground
Table 3-11:
Analog Output Mating Connector Ratings [-EB1]
Specification
Type
Part Numbers
Conductor Cross
Section
Conductor Insulation Strip Length
(1) Refer to the manufacturer website for additional information.
Figure 3-8:
Analog Output Typical Connection [-EB1]
www.aerotech.com
Solid or stranded
Stranded, with ferrule, without
plastic sleeve
Value
-10 V to +10 V
5 mA
16 bits
Connector
In/Out/Bi
Output
Output
Output
N/A
Description
4-Pin Terminal Block
Aerotech: ECK02399
Phoenix: 1768004
20...26 AWG (0.14...0.5 mm
20...24 AWG (0.25...0.5 mm
8 mm (5/16 in)
iXC4e/XC4e
2
)
2
)
97