Put The Analyzer Into State And Timing Modes - HP 1660 Series Training Manual

Put the Analyzer into State and Timing Modes

In this exercise you will use both the timing analyzer mode and the state
analyzer mode to correlate the state and timing measurements. Pod 1 will be
capturing the state measurement and Pod 3 will be capturing the timing
measurement. All other pods will be unassigned.
Press the
1
In the Analyzer 2 box, highlight the field to the right of
2
the
Select
Select
Highlight the Pod A3/A4 field, and press the
3
Machine 2
If you have any other pod pair fields other than A1/A2 and A3/A4,
4
select each pair and choose
Analyzer 1 is in state
mode with the lower 8
bits of Pod A1 and the J
clock are showing
activity.
Analyzer 2 in timing
mode. The lower 8 bits
of Pod A3 and the L clock
are showing activity.
Putting the Analyzer into State and Timing Modes
Result Analyzer 1 is in state mode with Pod 1 assigned to it. Analyzer 2 is in timing
mode with Pod 3 assigned to it. The remaining pods are unassigned.
Mixed Mode - Correlation of State and Timing Data
MENU key.
Config
key. Highlight
Timing
key.
in the pop-up menu, and press the
Unassigned
Get other manuals https://www.bkmanuals.com
Put the Analyzer into State and Timing Modes
Type
in the pop-up menu, and press the
key. Highlight
Select
key.
Select
in the pop-up menu.
If you are using a 1660, 1661,
1670, or a 1671 set Pod A5/A6
to "Unassigned".
If you are using an HP 1660 or
an HP 1670, set Pod A7/A8 to
"Unassigned".
, and press
5-5