Set The Jumpers - HP 1660 Series Training Manual

Triggering the Oscilloscope with the Timing Analyzer

Set the Jumpers

Set the Jumpers
You will create the glitch on bit 7 of the counter on the training board by
setting the glitch jumper to ON.
•
Set the jumpers as shown below.
For more information about setting the jumpers, refer to chapter 11, "To Set
the Jumpers."
CLK2
CLK1
GLITCH
Setting the Jumpers
Result
The glitch on bit 7 is turned on.
8-4
P. G.
OSC
P. G.
CLK2
J1
OFF
ON
Get other manuals https://www.bkmanuals.com