HP 1660 Series Training Manual page 8

Contents
Change the Jumper to Acquire a Different State Listing 4-8
Run the Analyzer and Find the Errors 4-9
5 Mixed Mode - Correlation of State and Timing Data
Before You Begin 5-3
Connect the Timing Analyzer 5-4
Put the Analyzer into State and Timing Modes 5-5
Change a Label Name and Modify Channel Assignments 5-6
Turn on the TCOUNT Label in the Waveform Menu 5-6
Clear the Timing Analyzer Trigger 5-7
Set Up the State Trigger Specification 5-7
Enable Time Correlation between the Timing and State Analyzers 5-8
Arm the Timing Analyzer with the State Analyzer 5-9
View the Mixed-Mode Display with Time-Correlated Markers 5-10
6 Advanced State Triggering
Before You Begin 6-3
Put the Analyzer into State Mode 6-4
Define State Trigger Terms "a" through "d" 6-5
Define State Trigger Term "e" and Range1 6-6
Add State Trigger Sequence Levels 6-7
Set Up Level 1 of the State Trigger Specification 6-8
Set Up Level 2 of the State Trigger Specification 6-9
Set Up Level 3 of the State Trigger Specification 6-10
Set Up Level 4 of the State Trigger Specification and Define a Combination
Trigger Term 6-11
Check the Trigger Specification 6-13
Run the State Analyzer and View the Data 6-14
7 Using the Oscilloscope
Before You Begin 7-3
Connect the Channel 1 Oscilloscope Probe 7-4
Get the Waveform on the Display 7-5
Delete Channel 2 from the Display 7-6
Zoom and Scroll Through the Clock Waveform 7-7
viii
Get other manuals https://www.bkmanuals.com