Table of Contents
Advertisement
Before You Begin
Decide what to do next.
1
If you have just completed "Ready, Set, Run", go to "Change a Label Name" on
page 2-5.
If you have not just completed "Ready, Set, Run" go to step 2.
Turn off the analyzer by pressing the power switch. Wait at least five
2
seconds, then press the power switch again to turn on the logic
analyzer.
Cycling the power defaults all system settings. This sets up the analyzer so
you can perform the remaining exercises.
Connect Pod 1.
3
Connect Pod 1 of the analyzer to J1 on the Training Board. For the HP 1660s
analyzer, Pod 1 is the top cable in the left-most position when you are facing
the rear of the logic analyzer. For the HP1670s, Pod 1 is the top cable in the
right-most position when you are facing the rear of the logic analyzer.
Set the jumpers as shown below.
4
The jumper settings of J5 on the training board for this chapter are the same
as the default settings.
Setting the Jumpers
See Also
"To Set the Jumpers" and "To Load a Configuration File" in chapter 11 for
more information.
J1
Get other manuals https://www.bkmanuals.com
Introduction to Timing Analysis
Before You Begin
2-3
Advertisement
Table of Contents
