Get The Waveform On The Display - HP 1660 Series Training Manual

Get the Waveform on the Display

The Autoscale feature automatically scales the vertical sensitivity and the
horizontal time base of the oscilloscope to provide a display of the waveform.
This simplifies the setup of the oscilloscope and is very helpful when the
amplitude and period of a signal are unknown.
Press the
1
Highlight the field in the top, left corner of the display and press the
2
Select
key.
Highlight the
3
Continue
The analyzer is in scope
mode.
This field initiates the
Autoscale feature.
Channel designator
Training board
clock signal
Getting the Waveform on the Display
Result
The training board clock signal is automatically scaled and is displayed in
channel C1.
key.
Config
key. Highlight in the pop-up menu, and press the
Scope
field and press the
Autoscale
in the pop-up menu, and press the
Get other manuals https://www.bkmanuals.com
Using the Oscilloscope
Get the Waveform on the Display
Select
key. Highlight
Select
key.
Select
7-5