Comparing State Traces
Check the Configuration
Check the Configuration
Either you have just completed chapter 3, "Introduction to State Analysis", or
you have loaded the configuration file CH_04.
If you are using an HP 1660 series analyzer go to step 2. If you are
1
using an HP 1670 series analyzer, put the analyzer into State Compare
mode before checking the configurations.
To do this, press the Config MENU key. In the Analyzer 1 box, highlight the
field to the right of Type, press the Select key, and then choose State Compare
from the pop-up menu.
Check the configuration.
2
•
In the Config menu, Analyzer 1 is set to State mode for the HP 1660s and
State Compare for the HP 1670s.
•
In the Format menu, the Master Clock field is displaying J ↓.
•
In the Format menu, the SCOUNT label is turned on with the lower eight
channels of pod A1 assigned to it.
•
In the Trigger menu SCOUNT's term "a" is assigned the value FF (hex).
4-4
Get other manuals https://www.bkmanuals.com