Table of Contents
Advertisement
Connect the Oscilloscope Probe
Connect the oscilloscope probe to channel 1 on the front panel.
1
Connect the probe tip to the test point labeled "Glitch" on the Logic
2
Analyzer Training Board.
Note that this is a different test point than the "CLK 1" test point that was
used in Chapter 7.
Connect the probe ground lead to the test point labeled "Ground" on
3
the training board.
Note
Leave Pod 1 connected to J1. This provides +5 V for the training board.
If Pod 1 is not connected to J1, connect it now.
J1 - Pod 1 of the
analyzer connects
here.
GND - Oscilloscope
ground connects here.
GLITCH - Oscilloscope
probe tip connects here.
Connecting the Oscilloscope Probe
Triggering the Oscilloscope with the Timing Analyzer
Get other manuals https://www.bkmanuals.com
Connect the Oscilloscope Probe
8-5
Advertisement
Table of Contents
