To Set The Jumpers - HP 1660 Series Training Manual

To Set the Jumpers

Pull the appropriate jumper off of the pins of J5.
1
Push the jumper onto the correct pins of J5. You only need to change
2
jumpers that differ from the settings in table 1.
Set the jumpers at their default settings for all chapters. Table 1 shows you
the default settings and the settings for each chapter. Chapter 4, "Comparing
State Traces," and chapter 8, "Triggering the Oscilloscope with the Timing
Analyzer," requires you to change the setting of the glitch jumper.
J5 - Jumpers are set
here.
Setting the Jumpers
Setting the Jumpers and Loading the Configurations
Get other manuals https://www.bkmanuals.com
To Set the Jumpers
P. G.
CLK2
OSC
P. G.
CLK1
CLK2
OFF
GLITCH
ON
Glitch OFF
P. G.
CLK2
OSC
P. G.
CLK1
CLK2
OFF
GLITCH
ON
Glitch ON
11-3