Dsa Emulex Adapter Test Results; Test - Lenovo System x3100 M4 Installation And Service Manual

Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. If the system has stopped responding, turn off and restart the system and then run the test again.
2. Make sure that the DSA Diagnostic code is at the latest level.
3. Run the test again.
4. Check system firmware level and upgrade if necessary. The installed firmware level can be found
in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
5. Run the test again.
6. If the system has stopped responding, turn off and restart the system and then run the test again.
7. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
– Lenovo Support website
–
Latest level of DSA

DSA Emulex adapter test results

The following messages can result when you run the Emulex adapter test.
Test results for the DSA Emulex adapter test
The following messages can result when you run the DSA Emulex adapter test.
• 516-000-000 : ELXUCNA: NIC MAC LoopBackTest Passed
The test passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Related links
–
Lenovo Support website
–
Latest level of DSA
• 516-001-000 : ELXUCNA: NIC PHY LoopBackTest Passed
The test passed.
Appendix C. DSA diagnostic test results
465