Table of Contents
Advertisement
3. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Removing the upper bezel
This procedure applies only to the 5U server model with hot-swap power supplies (Model name: 2582-F4x).
To access the DVD drive or tape drive on the 5U server model with hot-swap power supplies (Model name:
2582-F4x), you must first remove the upper bezel to access the devices.
To remove the upper bezel on the 5U server model with hot-swap power supplies (Model name: 2582-F4x),
complete the following steps.
1. Read the safety information in
2. If you are replacing a non-hot-swap component, turn off the server and all attached devices; then,
disconnect all power cords and external cables.
3. Unlock and remove the side cover (see
4. Remove the lower bezel (see
5. Carefully pull the two bezel clips on the left side of the upper bezel; then, rotate the upper bezel to the
right side of the server to disengage the two right-side tabs from the chassis.
Bezel clips
6. If you are instructed to return the upper bezel, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Replacing the upper bezel
This procedure applies only to the 5U server model with hot-swap power supplies (Model name: 2582-F4x).
To install the upper bezel on the 5U server model with hot-swap power supplies (Model name: 2582-F4x),
complete the following steps.
1. Insert the two tabs on the right-side of the upper bezel into the corresponding holes on the right side of
the chassis.
System x3100 M4 Installation and Service Guide
152
"Safety" on page v
and
"Removing the side cover" on page
"Removing the lower bezel" on page
"Installation guidelines" on page
145).
150).
30.
Advertisement
Table of Contents
Troubleshooting
