Lenovo System x3100 M4 Installation And Service Manual page 249

System board
(7 screws)
5. Install the seven screws that secure the system board to the chassis.
6. Install any of the following components that you removed from the system board:
• SAS/SATA ServeRAID adapter (see
• Battery (see "Replacing the system battery" on page
• DIMMs (see "Replacing a memory module" on page
• Microprocessor and heat sink (see
• Adapters (see "Replacing a ServeRAID adapter" on page
7. Reconnect any cables to the system board that you disconnected during removal (see
internal connectors" on page
8. Secure the cables with the retention-clips.
9. Install the air duct.
10. Install the side cover (see
11. Stand the server back up in its vertical position.
12. Install bezel (see "Replacing the bezel" on page
13. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Important: Perform the following updates:
• Either update the server with the latest RAID firmware or restore the pre-existing firmware from a
diskette or CD image.
• Update the UUID (see
• Update the DMI/SMBIOS (see
• Clear the CMOS data (see JP1 in
"Replacing a ServeRAID adapter" on page
"Replacing a microprocessor and heat sink" on page
25).
"Replacing the side cover" on page
149).
"Updating the Universal Unique Identifier (UUID)" on page
"Updating the DMI/SMBIOS data" on page
"System-board switches and jumpers" on page
185).
178).
155).
147).
96).
.
Chapter 6 Removing and replacing components
155).
226).
"System-board
94).
27).
235