Lenovo System x3100 M4 Installation And Service Manual page 178

9. Remove the drive retainer clip from the side of the drive cage of bay 1 or bay 2. Slide the drive retainer
clip to the front to remove it from the drive cage; then, snap the drive retainer clip into the screw holes on
the side of the drive.
Release
buttons
10. Push the drive into the bay.
11. Carefully turn the server on its side so that it is lying flat.
Attention: Do not allow the server to fall over.
12. Connect the power (power connector P9) and signal cables to the drive.
Note: Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
13. If you have another drive to install or remove, do so now.
14. Install the side cover (see
15. Stand the server back up in its vertical position.
16. Install the bezel (see
Note: Remove the filler blocking the installed drive if any.
17. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
To install a DVD drive on the 5U server model with hot-swap power supplies (Model name: 2582-F4x),
complete the following steps. For 4U server models with non-hot-swap power supplies, please see the
above sub-section.
1. Touch the static-protective package that contains the new DVD drive to any unpainted metal surface on
the server; then, remove the DVD drive from the package and place it on a static-protective surface.
2. Follow the instructions that come with the drive to set jumpers or switches, if there are any.
Note: You might find it easier to install the new drive from the front and then attach the cables.
3. Attach the drive retainer clip that you removed from the previous drive to the side of the new drive.
4. Push the drive into the bay.
System x3100 M4 Installation and Service Guide
164
"Replacing the side cover" on page
"Replacing the bezel" on page
Drive retainer
clip
147).
149).